In a digital paper cutting machine, every time a new blade is installed or an old blade is ground, it is necessary to manually adjust the height of the blade bed to adjust the cutting amount of the blade. This can effectively avoid accidents such as cutting too deep due to the high height of the blade. Therefore, we need to pay attention to ensuring that the motor is in a closed state when adjusting the blade, It can only be adjusted when it completely stops running. So, what are the specific operating steps for adjusting the digital paper cutting machine? Next, let me share it with you.

Paper cutting machine

1. Firstly, it is necessary to ensure that the paper cutting machine is in a knife changing state, stop the operation of its main motor, press the stop button of its main motor, and ensure that it is in a stationary state before the knife changing selection switch can be placed in the middle of the knife changing position.

2. Then, it is necessary to determine the cutting depth of the blade. At this point, we can use a socket wrench to rotate the nut on the end face of the belt pulley, so that the cutting bed can move to a certain low point. At the same time, we need to observe the depth of the blade to see if it is reasonable. Generally, the cutting depth of the blade is 0.5 to 1 mm.

In addition, for the adjustment process of the blade, if only one end of the blade edge and blade can be contacted, we can solve it by adjusting the eccentric shaft behind the main frame; When the blade cannot cut the paper properly due to wear and tear, we can move the blade downwards along its long hole direction until it can completely cut the paper.