After unremitting efforts, the level of domestic paper cutting machines and foreign products is rapidly declining, and old paper cutting machines are constantly being replaced by multi-functional, automated and high-tech computer paper cutting machines. But even for high-tech products, failure is inevitable. Next, let's take a look at the common failures of band saw computer Paper Cuttings machine in daily life. When the clutch clearance is too large or the friction plate is worn, the blade will not recover to the minimum point after cutting. When the blade edge is worn and the load is too high, the safety bolt breaks. 3. The hydraulic oil concentration is too high, and the compressor pressure is insufficient. 4. If the blade is not adjusted to the horizontal position or uneven blade, there will be a phenomenon where all the paper cannot be cut. 5. The paper is not pressed on the paper pushing device, the paper is not tightly pressed, and the paper is bent during Paper Cuttings. 6. There are defects on the blade and knife marks on the paper cut. Computer paper cutting machine